AnsweredAssumed Answered

FMCMOTCON1 How do I get the hardware Encoder Signals

Question asked by SteffenK on Apr 15, 2015
Latest reply on Apr 23, 2015 by SteffenK



Use rev design hdl_2014_r1 with an FMCMOTCON1


I want to get some information about the encoder signal from the dynamometer. What is the easiest way get on this data? I saw that the position_i[2:0] goes to the axi_mc_controller IP-Block and his signals to util_adc_pack_0 to axi_controller_dma. Does this mean the signal data is maybe already stored? If yes how can I address them? Or should I add a new AXI DMA connection?