I'm trying to figure out how to update EDID in an ADV7619 eval board.
I've taken following steps:
* Start with the board reset. EDID file is empty.
* Connect via HDMI and run repeater. This seem to update the board EDID file to that of a digital television.
* Turn off repeater and run script generated using EDID editor.
* Read the EDID file via Aves. The changes are present.
* Run repeater again. At this point instead of sending the updated EDID values, the board seem to reset the values back to the DTV settings. I want this to not happen.
What am I missing?