visual dsp ++ 5.0 . update 10.1
when i build the project ,the .dxe is smaller than 3338k ,for example 3336k, and load the dxe(debug mode) ,the program works。
but if the dxe file is bigger than 3338k, the program does not work right.
if the enable optimization is selected, it works well.
if the enable optimization is not selected ,it works wrong.
and sometimes , it hints this:
Core fault detected before halt at address: 0x00009600. Attempting to reset processor.
dsp : bf531 ,
Apologies for the delayed response.
Is this issue still open?
There is an FAQ on our EngineerZone forum which discusses techniques for narrowing down the cause of the Core Fault.
This is available here: http://ez.analog.com/docs/DOC-1361
Please provide the .dxe file to reproduce this issue so that we can assist you better
Retrieving data ...