I can't find Design Reference (gerber) files for EV-ADF5355SD1Z. Could you please provide me required files? Thank you in advance.
Can you share the BOM. I'm interested in which reference oscillators are being used (Y1, Y1_ALT).
Y1 is VCC6-LAB-122M880000 from Vectron International. "Low voltage differential signaling oscillator".
The full BOM will be in the ADF5355 evaluation board user guide which will be uploaded to Analog.com in a few days (UG-802).
Was the user guide uploaded?
searched for UG-802 and found only reference to the HRM of the CM40x MCU.
Would be glad if you'll post it/send it.
Many thanks for this "light" speed response.
Internal Compensation Node.
The ADF5355 data sheet says “DC biased at half the tuning range. Connect decoupling capacitors to the ground plane ACAP. “ and shows that way in the figure 55.
Where as eval board schematic (page 8 &9 ) it is mentioned “PLACE VBIAS, VREF 7 VREGVCO RESISTORS CLOSE TO DUT PINS” and it is shown to be connected to output of the VR2 5 Volts LDO
Data sheet says “Connect 100 nF decoupling capacitor to the ground plane ACAP.”
Where as in eval board, same thing is mentioned as above.
Outputs from the LDO Regulator. Nominal voltage of 1.8 V.
Does ADF5355 has a built in 1.8 V LDO which I can use to power some other device??
It might be very trivial but i would like to seek your advice and help.
Retrieving data ...