What is the right position for the jumper W9 in
for the Evaluation Board of AD9958 or AD9959 (page 3 of http://www.analog.com/media/en/technical-documentation/evaluation-documentation/57418637811849AD9959_pcb_0.pdf or http://www.analog.com/media/en/technical-documentation/evaluation-documentation/57241686299254AD995EB_0.pdf ) ?
I need to use it first with USB for test, then in external control in serial I/O mode single bit 2 wire though a microcontroller for example.
I need in this external mode to modify (for each channel) frequency (single tone mode), phase offset and DAC scale.
So, I think I can remove W1, W2, W3, W4, W5, W6 and W10. I need also to place W7 on GND (Manual),
Is this correct if I don't remove W9 ?
Thank you for the answer.