Clock source on evaluation boar of ADV7612 is crystal of 28.63636MHｚ.
Question1 Can I use oscillator ?
Question2 If possible, could you give me your advice about using oscillator
Yes you can use an oscillator to clock the ADV7612.
The oscillator should be fed into the XTALP pin of the ADV7612. XTALN pin should be left floating.
The oscillator should be 1.8V pp.
I advise using an oscillator with a 28.63636MHz frequency.
The oscillator must have an accuracy of 50 ppm over the entire temperature range of operation.
We have seen issues before where programmable oscillators have not had this level of accuracy. I advise using a non-programmable oscillator.
Analog Devices Inc.
Thank you for your advice.
Retrieving data ...