AnsweredAssumed Answered

ADZS-CM403F-EZLITE Programing Question

Question asked by MikeR Employee on Jan 20, 2015
Latest reply on Jan 21, 2015 by Praveen_H

Hello

 

My customer has purchased the ADZS-CM403F-EZLITE. They are using the Free
version of the IAR.  He was able to get the example program
“Button_LED_GPIO” to function properly on the demo board.

 

The next example program they tried to use was “dacc_linear”.  It
appeared to compile and program the chip, but when they select “go”, they see
no signal on pin 94 on the analog expansion board.  From the moment he hits
“Go”, within 10 seconds there is a message “Program exit reached”  at the
bottom  in the message box. Please advise how to proceed.

 

 

Outcomes