AnsweredAssumed Answered

How to apply single ended inputs to EVAL AD7961_FMC?

Question asked by on Jan 20, 2015
Latest reply on Jan 20, 2015 by



I'm trying to connect EVAL_AD7961_FMCZ board to ZedBoard and I need to apply and measure 16 bit single ended voltage between 0 to +4.096V range. How can I configure the board to run in single ended mode or is it already factory configured for single ended inputs?


Its mentioned in the documentation of the board, "The evaluation board is factory configured for providing either a single-ended path or a fully differential path as described in Table 1." (Table 1 attached). But its still unclear to me.


Also how can I change the range to 5V without applying external reference (from outside the board)?