I'm using the ADM13305-4ARZ supervisor and I've a problem with it.
I want to sense the voltages 3.3V and 1.2V. Therefore, I connected the 3.3V to SENSE1 and the 1.2V via a voltage divider:
This configuration is not working.
The ADM starts toggling the reset lines. I already checked the soldered connected, resoldered them etc. No success.
The voltages seem to be stable. Checked that already with my scope.
The only way to get a stable reset line is to remove the resistors and connect SENSE2 directly to +3.3V of SENSE1 but that is of course not what I want.
Any ideas? Your help is very much appreciated!