While trying to build POST code, there was error in compiling the rsi.c file. The scrrenshot of the error is attached. Please suggest the changes that have to be made to resolve this.
I'm using Finboard and CCES version 126.96.36.199
I recommend you start a new thread for the "YUV file on SD Card" question. If you contact private support, we can make an earlier release of the BF609 BSP available to you to try on your Finboard:
Please include a link to this thread when you contact private support.
Is this our POST example (for the BF609 EZ-KIT Lite), or a POST example specifically for the FinBoard? If you are using our POST example, what version of the BF609 EZ-Board Board Support Package have you installed?
In our source code, there is a definition for BITM_RSI_STAT0_CEATAINT on line 19 of the RSI test file "rsi.c" within the POST - does yours have this?
#if (__CCESVERSION__ != 0x01000000) && (__CCESVERSION__ != 0x01000100)
#define BITM_RSI_STAT0_CEATAINT (_ADI_MSK(0x00000020,uint32_t)) /* CEATA Interrupt */
(The result of this code is that the definition should be disabled for CCES 1.0.0, or CCES 1.0.1. You indicate that you are using CCES 1.1.0, so this definition should be enabled).
I got it right. But I couldn't run this example for finboard(bsp for finboard is given) as the processor rev in this board is 0.0. This is equivalent to BSP of ezkit rev 1.1. I tried with EZKIT bsp rev 1.0.2 but even this supports processor rev 0.1 or higher only. Is there any older version of POST code which works with this board.
Although I was able to run this code on bf609 EZKIT with processor rev 0.1
I also need guidance on the following
My problem: I have a yuv file stored in SD card(consider any linux/windows file system). How do I read this file for further processing. Is there any example available?
Thanks a lot!!
Retrieving data ...