I followed all the directions to use an external reference found atFMCOMMS2 - external reference clock but I'm getting a few errors on boot and I can't display a signal in the oscilloscope.
ad9361 spi32766.0: Calibration TIMEOUT (0x247, 0x2)
ad9361 spi32766.0: Calibration TIMEOUT (0x287, 0x2)
ad9361 spi32766.1: ad9361_dig_tune: Tuning RX FAILED!
ad9361 spi32766.1: ad9361_dig_tune: Tuning TX FAILED!
I set the clock to 10MHz and plugged in a 10MHz reference clock. I removed the resistor and placed the capacitor per the instructions.
What could be the issue here?