AnsweredAssumed Answered

"DIAG1_SLICER_PWRDN" is described on 0x5E (DIAG2 Control) bit 6 on the Manual.

Question asked by Tamu on Dec 25, 2014
Latest reply on Jan 6, 2015 by Tamu


I have a question about manual "ADV7280_7281_7282_7283_UG-637.pdf".


There is following description on the manual Page 81.

0x5E (DIAG2 Control) bit 6 is "DIAG1_SLICER_PWRDN".
  "Power up the DIAG1 slicer"
  "Power down the DIAG1 slicer"


I think 0x5E are registers about DIAG2.
Is the "DIAG1" typo?
If it's so, please fix the descriptions.


Thank you.
Best regards.