I'm looking for a data sheet for the HMC6000. Also, I would like to know if there is any evaluation board/platform available.
The URL below provides some detail on the HMC6000/HMC6001 and the evaluation kit. You can also request full data sheets from the URL.
How can I get further guidance and application notes to use HMC6000/HMC6001 in AM/FM/FSK/MSK waveforms directly on-chip? I am interesting in these modes.
The attached document provides an overview on how to use the HMC6000/HMC6001 in MSK mode. This is typically what's used if a complex I/Q baseband is not available or not necessary.
Thank you for MSK reference.
When I will use HMC6001 in FM mode what kind bits I need setting up and what kind of outputs will be used? How will affect table 8 ROW 3 settings in low/high pass corners of the baseband amplifiers to FM demodulated signal? Do the filters cut off low and high frequencies of demodulated signal?
I recommend leaving the RX HPF at the lowest frequency (logic 00) and the RX LPF at the highest frequency (logic 00). Depending on the signal BW, the LPF can be adjusted lower. But it will degraded the frequency response of the channel, refer to figure 19 in the HMC6001 datasheet.
Retrieving data ...