AnsweredAssumed Answered

ad9361.cfg for using simulink with AD-FMCOMMS5-EBZ in a 4x4 MIMO configuration

Question asked by elvisjohndowson on Nov 17, 2014
Latest reply on Nov 20, 2014 by elvisjohndowson

Hi,

 

Where can I find the list of parameters so that I can modify the ad9361.cfg file, to expose all 4 transmit and receive channels for an AD-FMCOMMS5-EBZ board with dual AD9361 RF transceivers?

 

The following the a the cfg file for a single channel receive. I'd like to modify the file to expose all 4 transmit and receive channels on the AD-FMCOMMS5-EBZ.

 

data_out_device = cf-ad9361-lpc
ctrl_device = ad9361-phy
channel = RX_LO_FREQ,IN,out_altvoltage0_RX_LO_frequency,
channel = RX_SAMPLING_FREQ,IN,in_voltage_sampling_frequency,
channel = RX_RF_BANDWIDTH,IN,in_voltage_rf_bandwidth,
channel = RX1_GAIN_MODE,IN,in_voltage0_gain_control_mode,
channel = RX1_GAIN,IN,in_voltage0_hardwaregain,
channel = RX1_RSSI,OUT,in_voltage0_rssi,

 

 

Regards,

 

Elvis Dowson

Outcomes