AnsweredAssumed Answered

ADuc7061MKZ and JTAG

Question asked by dilbert on Oct 9, 2014
Latest reply on Oct 9, 2014 by dilbert

Hello,

Does anyone have any experience of using a JTAG debugger with this board? Can you recommend the best budget JTAG device? I also have a  7128 dev kit that was supplied with a miDAS-Link, can i somehow use this?

 

I have reached the limit of debugging without decent simulation. I cannot seem to simulate the device in a meaningful way within keil IDE, i can run the debugger but it does not appear to have any interaction with the peripherals. Does anyone have a config or similar that would allow simulation of the device and its peripherals within Keil? Ideally I would like to input waveforms to the counter and GPIO pins and observe the outputs during debug.

 

Thank you

Dilbert

Outcomes