I need help on the following questions regarding ADIS16210/PCBZ. Any help regarding the same will be appreciated.
1. What is the pin layout(numbering) of the J1 connector on the breakout board of ADIS 16210 ?
2. What is the pin configuration(which pin represents what) of the J1 connector on the breakout board ?
3. How do I interface this breakout board alone without any Eval board with the Arduino UNO ?
Note: I did not find much in the datasheets about the pin layout. I do not want to risk the sensor by assuming that it is the same as the other series of sensors.
Thanks in advance.