AnsweredAssumed Answered

ADIS16209

Question asked by Tilt_Jagdish on Aug 9, 2014
Latest reply on Aug 10, 2014 by Tilt_Jagdish

I use ADIS16209 evaluation board with TI controller. I not set means not write any control register & assume that it is ok as per datasheet.

1. My target is to measure X or Y axis both side with 0.05 degree accuracy. Is it possible with this ?

2. How much delay require between 2 reading so that I get stable & accurate reading ?

3. Is any sample code or process algorithm available so that I can follow it to get me require above accuracy ?

4. I read this reading but around 4-5 bit variation occur so I reduce it ?

5. Is AVG_CNT register help me to reduce above variation or to get stability ?

 

In advance thanks for reply or suggestion

 

Jagdish

Outcomes