AnsweredAssumed Answered

How to send RF Modulated Signal using Fiber Optic

Question asked by amartin32@g.ucla.edu on Aug 4, 2014
Latest reply on Dec 10, 2014 by Dongfeng

Hello I am new to this.

 

I am looking for a clean way of transmitting analog signals via a fiber optic cable. So the constraints are the method must allow 10 Mpbs sample rate or higher and if a adc of some sort is used then it must be 12bits or higher. I was looking at the laser driver specifically the ADN2525 and would like to know if it has the capability to send a RF signal (AM or FM) in place of the Pattern Generator? I understand that all of the laser drivers were not designed for this application but am wondering if these drivers can be used in this type of application.

 

 

I appreciate any feedback! Thanks!

Outcomes