I'd like to ask about BF70x JTAG pin for my customer's new design.
According to "ICE-1000/ICE-2000 Emulator User's Guide" page 1-6, "Figure 1-3 J2 Pinout" show pin#7 as TDI.
But EZkit Schematic on "ADSP-BF707_ezkit_man_rev.pdf", pin#7 of P3 conector is OPEN(NC).
Which one is correct circuit for BF70x JTAG?
ADSP-BF70x doesn't have EMU signal. Is there any concern(Pull Down/UP, connect GND/VCC) for JTAG-ICE EMU signal or leave NC?
Thank you for your help in advance.