AnsweredAssumed Answered

"configure clock and power settings" disabled

Question asked by TonyKaravidas on Jul 28, 2014
Latest reply on Jul 29, 2014 by DavidS

I'm running VDSP++ 5.1.1. I'm trying to set up a project using the project wizard, and it goes fine until I get to the "processor clock and power settings" section. It is all disabled, and I think it's because the tool thinks I'm using an EZKIT. I did install my first license using a KIT license, but I'm now using a TST license. I am using custom hardware.

 

Any idea how to tell the tool I'm not using a blackfin demo board, and have it enable this project wizard page?

Outcomes