Hi, I was wondering if there are any code examples outlining how to configure the BF60x so that incoming PPI data is automatically streamed to a DMA channel and to trigger an interrupt?
I have moved this thread from the Processors and DSP community to the ADSP-BF60x community. Please continue the discussion here.
I have attached an example code which configures EPPI of BF609 to receive data through EPPI in 1FS mode you may use it as a reference.
Note that pin multiplexing is not included in the code you may do it using CCES->Project->system.svc->select EPPI0 save and rebuild the project.
Please refer chapter 31 “Enhanced Parallel Peripheral Interface (EPPI)” in BF60x HRM for more information on EPPI, you may find the BF60x HRM at the below link:
Retrieving data ...