I follow your manual default configuration for my kit revision 1.7 for ADSP-BF527-EZKIT LITE 2.2 ,but the RESET LED on when i power ON the supply,This is fault how to rectified that one
I've branched off your post into a new thread as it wasn't strictly related to the thread you replied to. I've also moved the new thread to the Hardware Tools community.
In your post I believe you mean you've followed the default configuration in rev 1.7 of the BF527 EZ-Kit manual. Is this correct?
By default the Reset LED will flash on when power is connected for the first time. Is this what's happening to you or is the Reset LED (LED 5) remaining lit the all the time (i.e. it's coming on when the power is supplied but not going out again)?
You reported something similar in a previous thread where the reset LED would only light up after you tried to load an application to your board. Did the same thing happen here? Did you only encounter this behaviour after loading an application to the board? Were you trying to run a DXE or and LDR file?
If your board is being stuck in reset (LED 5 does not go off) then it could be due to the target board booting corrupt code. The best way of troubleshooting this is to change the Boot Mode switch (SW 2) away from it's current location, and then power cycle the board. When you power the board again, can you please confirm the Reset LED now goes out?
Retrieving data ...