AnsweredAssumed Answered

Adding Linux to AD-FMCJESDADC1-EBZ reference design

Question asked by Rohan on Jun 10, 2014
Latest reply on Jun 12, 2014 by larsc

I have a ZC706. I have been able to build the reference design (ADI AD-FMCJESDADC1-EBZ Boards & Xilinx Reference Design [Analog Devices Wiki]) from its source (using Xilinx ISE/EDK/SDK 14.4) and boot it from a SD card. I would like to also boot Linux. Can someone please point me to a good guide on how to do this? I see that there are similar solutions located at Zynq Quick Start Guide [Analog Devices Wiki], but I would like to know how to produce these images from scratch. Ideally, I would like to 1) program the FPGA with the reference design hardware, 2) run the reference design software, and 3) run Linux all from the SD card.

 

Is this even possible? Would I have to port the reference design software to Linux? Also, is it possible for me to utilize the Xilinx pre-built Linux images (www.wiki.xilinx.com/Zynq+Releases) without building my own?

 

Thanks,

Rohan

Outcomes