AnsweredAssumed Answered

How to make IMU sensors insusceptible to surrounding electronics?

Question asked by DaoYanLim on Jun 5, 2014
Latest reply on Jun 11, 2014 by DaoYanLim

Hi,

 

I am using two IMU sensors to perform the same tests and they are: ADIS16360 and ADIS16362.

 

I attached my IMU sensor on a robot arm to take some data and the gyroscope measurements were always out of calibration after one or two trials. I took the data with EVAL-ADIS board. The robot's control box is about 2 feet below the arm on which the sensor was attached to. I currently have my sensor wrapped in layers of aluminum foil but that wasn't helping either. Is there something I can do to prevent this?

 

Thanks,

Dao.

Outcomes