About a week ago my EVAL-ADV7625-SMZ stopped outputting HDMI.
Anyway to reset the board to the shipping defaults to make sure its not something I mis-configured?
By default, the application binary for EVAL-ADV7625-SMZ will route video:
* from RXA (J2) to TXA (J7)
* from RXB (J3) to TXB (J8)
Have you reprogrammed the application binary? Do you still have the u-boot bootloader?
Have not reprogrammed the application binary and u-boot looks ok on the com port watching it boot.
Also seeing HDMI insertions logged on the com port as well, but no video output!
Not sure how I missed this up
My coworker has a 2nd board we will try tomorrow for a demo which he has not touched yet.
Are both datapaths not working?
Ok so it seems to have taken a turn for the worse.
Now it stops after "initializing USB"
U-Boot 2012.07-rc2 (ADI-2012R2) (Jul 01 2013 - 15:24:32)
CPU: ADSP bf524-0.2 (Detected Rev: 0.2) (spi flash boot)
Board: ADI Advantivb" Video Evaluation Board
Clock: VCO: 300 MHz, Core: 300 MHz, System: 100 MHz
RAM: 8 MiB
SF: Detected M25P80 with page size 64 KiB, total 1 MiB
*** Warning - bad CRC, using default environment
KGDB: [on serial] ready
Hit any key to stop autoboot: 0
## Booting ldr image at 0x00100000 ...
EVAL-ADV7625-SMZ Application built on Nov 20 2013 at 14:34:13
Heap Space: 22496 bytes free
Diagnostic Interface set to UART.
Should I try re-flashing the binary? ADV7625_v1p65_app.bin.
Is that available anywhere?
And it is doing this while I ONLY have RS232 connected. No other peripherals...
It sounds like your board is defective. We will work with you to get a replacement.
Retrieving data ...