AnsweredAssumed Answered

ADV7611 board jumper settings

Question asked by Bernd.K Employee on May 7, 2014
Latest reply on May 12, 2014 by Rob.Analog

Hi,

 

The ADV7611_EvalNote_RevA document names the default jumper settings in chapter 5.1.2.

 

a) the default settings does not fit to the jumpers shown at the board picture figure 1. That might be a problem

b)

What about point 5. MCU IC” (SDA,SCL) of Jumper settings? I cannot find this on the board schematic or picture. Is it relevant?

 

Best regards, Bernd

Outcomes