AnsweredAssumed Answered

Sharc emulator connection - Target Not Halted

Question asked by BG1 on Apr 30, 2014
Latest reply on May 5, 2014 by CraigG

I have a new board I am trying to bring up with 2 ADSP21489.

 

I get the following error message when trying to connect to a session Error 0x80048042 Target is not halted.

Using VDSP++ and HPUSB-ICE

I ran the configurator and it passes all jtag tests including repetitive test.  Recognizes

The SDRAM clock is active and makes sense with the boot clock configuration.  It goes inactive if I hold reset low, again as expected.  This is true on both processors.1.1V and 3.3V supply both look good.

I have an earlier version of this board running with no problems and I can't see what else could be wrong.

My emulator and session works on the different board too.  Any suggestions for places to look would be appreciated.

Outcomes