I had problem to use an USB Adapter board . i try to fix it but i burn wrong hex file to EEPROM.
I find other way to use it without an USB Adapter.
I can't find the old software for use EVAL-ADF411XEBZ1 with LPT Port.
Give me pls.
Attached. It's been a long time since this was supported so you use it at your own risk.
Make sure you install it as administrator. If not, you may not have permission to access the LPT port. It should work on Windows XP. If you have Windows 7, you'll need to use Windows XP emulator. It installs a virtual Windows XP machine and you install the Integer-N software inside the virtual machine. Free download here: http://www.microsoft.com/windows/virtual-pc/download.aspx
I use it with Windows XP and ADI PLL Int-N Rev.7.3.1 but it still don't work.
Did you try the v5.1 software attached above?
When I measure RF out from my eval board , It generate frequency @ 1.66 GHz.
I use V.5.1 with LPT Port and I'm try to change VCO frequency to lower or upper. the frequency don't change together.
I uploading video when i using sweep mode and monitor transition in spectrum analyzer monitor on youtube.
Hope you will help me.
PS. sorry if my English is hard to understand.
VIDEO Link : http://www.youtube.com/watch?v=i8cS5FG7WxY
URL : http://www.youtube.com/watch?v=i8cS5FG7WxY
Are you seeing any signs of successful communication between the software and the board:
I try to toggle Phase Detector Polarity the output frequency doesn't change.
*edit Finally, I found the problem , my eval board had set LK2 jumper (CE) to LOW.
I fix it and I try to change Phase Detector Polarity , the output frecquecy can change.
the RF VCO Output frequency that i had setup and the RF OUT didn't correctly.
What is your reference frequency? Please send a screenshot of your software settings.
Are you using the standard evaluation board loop filter?
Retrieving data ...