I would like post a EMI issue from a system with BF537 as main processor.
From the EMI test report, you can see there are some obvious spur over the mask. I want to find the reason where it is from? Are they related with DSP itself?
Below are more information about this system:
SPORT was disabled by SPORTx_TCR1, TSPEN bit, the rate is 750KHz
Four layers, there are chips and signals; GND;3.3V;signals. No seperate layer for 1.2V
There is a flexible cable from this system to another one, I have added 33 ohm (besides BF537) into some signal lines ,which are across the two boards.