AnsweredAssumed Answered

Tx power monitor damages tx/rx signal

Question asked by akoynov on Mar 29, 2014
Latest reply on May 30, 2014 by Ivan-Rusov

This supposed to be a reply to this tread http://ez.analog.com/message/136724 but on some reason neither my collegs nor myself are able to submit replies to that. We are getting back a error message like "An error occurred while trying to submit your post. Please try again."

 

Anyway, as was adviced we tried the following:

 

0x001 = 0

0x057 = 0x30

0x06e = 0x4 (RX state) / 0xA4 (TX state)

 

and getting transmitted signal damaged this time according to 0x06E[D7 & D5] bit mask: if only one of these two bits is set during TX state, the signal on the relevant antenna gets messed out, but the other one remains good.

Outcomes