Dear My friends
Pls refer to attached file.
Audio source on my BlueRay player is DTS or DOLBY. Now I need this audio output to my SHARC decoder,
I connect my ADV7623 to SHARC only use single pin AP0_OUT.as a SPDIF signal.
An issue is my SHARC always recognize the input signal as 2-ch PCM, not DTS ot DOLBY.
I can make sure my SHARC decoder is good.
if any one can tell me how to config the register on ADV7623 to let DTS/DOLBY output on AP0_OUT pin?
or if the EDID configuration is must be do? how to define EDID content?