I am currently trying to implement the ADXL345 into a project but am coming across issues with the Data_ready interrupt. I am only using this interrupt in order to sample data at the full 3200Hz
I initiate the device in the following way:
Set the sample rate to 3200,
Set the Dataformat to 0x0B: Full res at -+16g.
Enable the DataReady Interrupt: 0x80
Map to pin one: 0x00
Bypass FIFO: 0x01
I then read the acceleration data to clear the interrupt.
This however is not detected by my microcontroller (Tiva C Launchpad). I am using I2C and I am able to communicate with the accelerometer.
The interrupt is set up correctly on the Tiva C as it working with a previous accelerometer.
Thanks in advance.