AnsweredAssumed Answered

Will the ADUC7023 init to default settings if the entire Flash is erase?

Question asked by Linc on Mar 8, 2014
Latest reply on Mar 10, 2014 by ABuda

I have tired to load the Demo.c code using RDI/JTAG interface on the ADUC7023 Eval board. The Demo.c code was successfully "rebuild all target files". During the programming process the Erase, Programming and Verify OK were correctly displayed. However, I when attempted to vary the Potentiometer the Demo Circuit LED did not glow. I am using Keil uVision3 IDE. I would certainly appreciate any guidance before I erase the full chip, thanks.

 

Outcomes