Using an EZ-KIT Lite 21061 for a final year uni project and would like to use the RS-232 interface to communicate with a unitronics PLC. The PLC will be used to send parameters to the DSP every so often by writing to specificied memory locations, similar to the way described in EE-87 and chapter 6.3 of the 2106x Reference Manual attached.
I would like to begin by testing the interface out with hyperterminal as per CraigGs instructions (15/09/09):
I'm not getting any response though. I've used the EZ-KIT host program to test communications and it reported it was fine. Any suggestions?