Can someone verify that these are the correct pin mappings for a sharc 21375 slave boot:
SPI MOSI -> DPI1
SPI MISO <- DPI2
SPI CLK -> DPI3
SPISS -> DPI4
The note on page 17-15 is a typo. MOSI is on DPI pin1 and MISO is on DPI pin 2 as given on page 6-31 on default for both master and slave boot.
Hope this clarififies. We will make sure the typo is corrected on page 17-15
The default routing you have below is right. It is given on page 6-31 of the hardware reference manual available at the following link.
Hope this helps.
Thank you for your reply. Just one more question: On page 17-15, at the bottom of the page, MOSI is indicated to be on DPI2. This seems to conflict with the information on page 6-31. MOSI should be on the same pin regardless of whether the boot mode is a SPI master OR a SPI slave, right?
Thank you very much for your help! I'm glad to hear that it's a typo; I was getting really confused!
Retrieving data ...