AnsweredAssumed Answered

Problems using the BF527 Button_LED_GPIO example

Question asked by Ram_92 on Feb 19, 2014
Latest reply on Apr 3, 2014 by DavidS
Branched from an earlier discussion
Branched to a new discussion

   Hi

       we using BF527 EZ kit.....we load the example Button_LED_GPIO to kit and debug it.they Run successfully but we didn't get answer .we also follow the Hardware setting as your mentioned (push button and switch).by manual follow below .....and also we check default  jumper setting .....there is no use ....the board indicate red LED ON ...kindly send default jumper&solution and button setting or notify us to how to neglect that one...

Untitled.png

Outcomes