AnsweredAssumed Answered

AD9467FMC connectivity with Zedboard

Question asked by umaair_653 on Feb 10, 2014
Latest reply on Jul 13, 2017 by CsomI

Hello all,

 

I want to interface AD9467FMC with Zedboard and Waveform Generator but i have some problems and confusions that what should i set on Zedboard jumper either 1.8V or 2.5V.

Secondly i want to use reference design for this and i connected like:

 

Zedboard(1.8V on J18) --------> AD9467FMC -----> SMA to BNC connector -----> Waveform generator (via BNC cable)

 

So this is the right scenario to check analog signal on chipscope pro???

 

Third very important i connected with this scenario but after 5 minutes ADC card becomes very warm, if someone knows then please share the reason.

 

Thanks.

Outcomes