Hi can any one tell me how to get the switch configuration (NO / NC / NC&NO / NA(Not Applicable)) for the parts which is unavailable in the website??? whether we can able to find it from diagram??? if yes how ??? for ex :ADG714BRUZ-REEL7
Normally open means that when digital controller is low the channel is conducting.
Normally closed means that when digital controller is low the channel is not conducting.
I do not understand your question. There are no NC (no connect) pins on the ADG714. The ADG714 data sheet is available on the website at the link below.
I am asking whether the switch is normally closed (NC), normally open (NO) or Normally closed and open .. i think so because am new to this product research for better understanding please refer ADG701BRT product http://www.analog.com/en/switchesmultiplexers/analog-switches/adg701/products/product.html in description they have mentioned as 4 ohm low voltage wide bandwidth single SPST IN 6-LD SOT-23, NC ..in the end they have mentioned as NC ....what it means??
I understand now. Whether a switch is normally open or normally closed will be on each individual data sheet and can be found from the truth table in the particular data sheet. For the switch state to be determined power and digital inputs must be set and so the truth table is the best place to find the information you are looking for.
Good morning .. Thank you for your kind response. Still i have struggle to confirm the switch configuration. Can you please explain me with a truth table for my better understanding ???
Thank you for the support..
Retrieving data ...