I'm looking for the schematic of "Rev.A" AD-ADC FMC interposer board.
I need it to consider that I can use AD9233-125EBZ with FMC or not.
Could you please tell me the link to it ?
The CVT-ADC-FMC-INTPZA is no longer in production and has been replaced by the CVT-ADC-FMC-INTPZB. The schematic and related docs for the CVT-ADC-FMC-INTPZB are avail at http://www.analog.com/en/evaluation/eval-adc-fmc-int/eb.html. The current CVT-ADC-FMC-INTPZB version addresses a few signal level-translation and pin-mapping anomalies that existed on the older CVT-ADC-FMC-INTPZA revA version.
The 14bit AD9649, 10bit AD9609, 12bit AD9629, and 16bit AD9266 are all members of the same low-power ADC family. All four models in this family use the same physical ADC eval brd. For your AD9266 interfacing project I would recommend looking at the AD9649 to CVT-ADC-FMC-INTPZB FPGA interfacing example code and docs noted on the link below. This AD9649 example should be similar to your intended AD9266 interfacing project.
There is a reference design available for interfacing the AD9649 to the KC705 using the CVT-ADC-FMC-INTPZB posted at https://wiki.analog.com/resources/fpga/xilinx/interposer/ad9649.
As requested, I'm attaching the older revA schematic for your review, but I think you may be better served by moving to the newer/current revB CVT-ADC-FMC-INTPZB interposer version.
I'm sorry, I have a mistake.
AD9233-125EBZ has different connector.
I wish use AD9266-80EBZ with AD-ADC-FMC interposer.
Can I have the schematic of AD-ADC-FMC Rev.A board ?
Hi Tony M,
Thank you for your support.
I did not know the Rev.B can be used for AD9266 eval board.
I thought that Rev.B was a interposer for JESD204.
I wish to use Rev.B according to your advice.
Retrieving data ...