Are there any specific measures I should take if I am designing one of your DDS evaluation boards into my system as a subsystem?
This is a BAD idea; you should not do it for a few reasons. The primary ones are:
1) ADI does not accept orders for multiple eval boards, we offer eval boards only as an evaluation vehicle for designers considering using the chip in a system design
2) Because these are intended for lab use, they are not tested across temperature, nor characterized or guaranteed outside a lab environment. Using them in an environment where the temperature is not controlled may well result in failures.
note that ADI WILL gladly help customers replicate our design by providing schematics and BOMs for our eval board.
Please reconsider your plans.
I would like to see
3) source code for embedded CY7C68013A (EZ-USB) microcontroller
in your list of available design tools for the AD9958/PCBZ
Please find attached the source code requested.
From: DSB firstname.lastname@example.org
Sent: Tuesday, November 02, 2010 2:49 PM
To: Peter Castagna
Subject: New message: "I am designing your eval board into my system"
Analog Devices EngineerZone <http://ez.analog.com/index.jspa>
I am designing your eval board into my system
reply from DSB <http://ez.analog.com/people/DSB> in Direct Digital Synthesis (DDS) - View the full discussion <http://ez.analog.com/message/15079#15079
Retrieving data ...