AnsweredAssumed Answered

USB connector to a custom 1701 board.

Question asked by Skfir on Aug 21, 2013
Latest reply on Aug 22, 2013 by Skfir

Hi!

Again a question appeared, now about the USB connection, I just wanted to clarify it a bit. According to the 1701miniz datasheet schematics, out of total 10 pins, by means of which the miniz board is connected to a PC, only 4 are used, right? SCL,SDA,GND and BRD_RST.  So does it mean that if I make my own board, I can use a smaller 4-pin connector? Also, on the figure, right above the pin 2 it is written "usb_clk", what does it refer to? I am just a bit confused...

Thanks in advance!

Outcomes