AnsweredAssumed Answered

PG0 / HWAIT, during Nand-boot

Question asked by dav on May 10, 2010
Latest reply on May 11, 2010 by dav

Hi,

 

Have a question about the HWAIT-pin on the 526 during Nand Flash boot.

 

In the hardware manual, 17-32

The HWAIT signal is, however, available in all boot modes with the exception of the NAND flash boot mode.

Does that mean that if we have the PG0/HWAIT pin tied to an output that potentially could be GND at boot.

 

Could that cause any problems you think?

 

 

 

/david

Outcomes