AnsweredAssumed Answered

PPI output

Question asked by mshearer123 on May 6, 2010
Latest reply on Jun 2, 2010 by PrasanthR

Hardware: BF561 dev kit




I am trying to configure PPI0 to Tx mode, 1 internal frame sync.  I don't yet have hardware to check if it is working, so just using the development kit to check the code/signals.


One problem I'm seeing is that after the dma transfer is complete I do disable the PPI ( *pPPI0_CONTROL ^= ((uint16_t)PORT_EN); )

Doing this clears the entire PPI0 control register.  So next time i run the function i need to re-configure the register.


Any advice on this would be great,