Page 15 of the datasheet describes how to eliminate sensitivity to lot-to-lot gain variation by adjusting the source and load impedance. How does this procedure make the circuit independent of the input and output impedances of the amplifier?
I have moved this question about AD8369 to the RF community. Someone here should be able to assist you.
The portion of the datasheet regarding gain sensitivity is inaccurate. In simulation done by the designer, there was very little gain variation over process corners with the AD8369 and no need to compensate for this as long the input and output of the AD8369 are loaded with 200 ohms. The datasheet will be updated to reflect this.
Could you please update with regards to this , was the datasheet updated .
We still see that the lot to lot variation still exists on the present data sheet Rev 0 .
With best regards and wishes
Apologies, the datasheet has not been updated, will happen soon,
Retrieving data ...