I'm using the NAND-Boot mode on a BF548. The reference manual
says, that a bad block marker has to be written to the last byte
of the spare area. However, as far as I can tell, the Blackfins
assume either 8 bytes or 16 bytes of spare area for each 512 bytes
block of data area.
I'm using a device from Micron, which has 28 bytes of spare area
for each 512 byte block of data area (page contains 8 such blocks).
For this device, do I have to write the bad block mark really into the
very last byte (i.e. column address 4319) or do I have to use the byte
at address 4096-1 + 8x16 = column address 4223 ?
Thanks & kind regards,