AnsweredAssumed Answered

Processor halts while starting "Run"

Question asked by AsifHabib on Nov 17, 2009
Latest reply on Jun 21, 2010 by AsifHabib



I am getting a strange problem from one of BF537 based boards. I am able to connect the VDSP to the board properly via HPUSB ICE. The program also loads properly on the board. However most of the time when I run some program on the board then it gives following errors (screenshots attached with message). And the program does not run anymore for that particular “run”. Then after restarting the board several times the program “may” run, or may not run.


Please note that this board was working perfectly all right, and this problem has arisen all of a sudden from nowhere. The same program also runs fine on other boards. Does this mean that the processor on that particular board has gone faulty? Is there any solution to this problem?


Best Regards,

Asif Habib