I've design a product around ADV7511. HDMI output works fine with any monitor (1920 x 1080i).
However, HDMI output is not detected by the blackmagic hypershuttle!
Any idea what's the root cause?
BTW, video is not copy protected (HDCP)
What are you writing to register 0xAF? Are you in DVI or HDMI mode?
I don't know anything about how the hypershuttle is designed but if it's working fine with normal monitors odds are it's something to do with HDCP, EDID, or maybe signal integrity on the PCB/cable.
0xAF was set to 0x16. I set it to 0x06 and it made no difference.
I am using 1080i x 60Hz with embedded sync.
Well 0x16 definitely was encrypted so that would not have worked but 0x06 should be unencrypted HDMI. Did you read the EDID that the device sends to confirm what formats it supports? Have you tried 1080p or 720p?
Retrieving data ...