through lcdviewer,i flash the u-boot that is absolutely right to the board successfully.why it cannot be displayed in terminal programme. patch:switch2 postion 7, baudrate 57600,8,1,none........please help.......god
Check if the boot mode switch setting is correct, it should match with the u-boot.ldr you flashed in. There is explicit information for the boot mode switch settings in the 609 board user manual.
thanks ,but trust me.i really do exactly as user manual....i choose windows terminal but it always display "B"....or do you lend a board that is finished (u-boot ok and kenal ok,anyway,it can run ok),in these days, i must do some tests in 609 to our customer
i can give you my board 609 i bought and you guys help me check it ,finish it. you lend me a 609 board which can run(uclinux kernal and u-boot as bootloader)
please please please please
i've send you an e-mail...please receive it......today is deadline,hope your answer........
Where is the bf609 u-boot ldr image you flashed to your board come from? 2012R2 release page on blackfin.uclinux.org?
What uart port do you use on your windows host? UART1 or USB UART dongle?
What baud rate do you set in your windows terminal?
Do you have a Linux host? such as ubuntu 12.04? Check in minicom.
Retrieving data ...