My board is ADSP-BF518F Evaluation Board, and with VDSP++ 5.0
Today I changed one line in my c program, then built the project as usual.
But this time, a dialog window came out saing "Target halted at breakpoints".
At the same time, the debug information is shown as:
Target halted due to software breakpoint but no breakpoint found at address: 0xXXXX
Possible reasons are:
1.An embedded breakpoint (EMUEXCPT instruction) in the code
2.A breakpoint is placed at the last instruction of a do() loop
After that, I ran the program and stop it in VDSP, the dialog came out again,
while the program can never go forward from then on. What's wrong with it?