AnsweredAssumed Answered

EZKIT BF548 NAND Boot

Question asked by vipul.mahajan on Mar 6, 2013
Latest reply on Mar 8, 2013 by Prashant

Hi,

 

I want to boot EZKIT BF548 using NAND. I modified init code to support NAND boot by adding code as suggested in Ch17 of Hardware Manual. The dxe file generated is used to flash NAND. After flashing I set the SW1 (Boot mode) to D i.e NAND but nothing is coming on LCD. The code we are trying to run is POST code provided in VisualDSP. The same code runs well with SPI.

Outcomes